IBM 86624RY Maintenance Manual - Page 156

f. Record the slot number for the ServeRAID adapter or controller; then, press Esc three times to return to the controller selection screen. g. Repeat step 3c on page 147 through step 3f until you record the slot number for each ServeRAID adapter or controller that appears on the selection screen. 4. Turn off the system; then, remove all ServeRAID adapters and controllers except the first one on the list. Note If one of the ServeRAID controllers that you need to remove is on the system board, you must do one of the following: If the CD-ROM drive that you are using to install the operating system is attached to the integrated ServeRAID controller, disconnect or remove all disk drives attached to the integrated controller. If only disk drives are attached to the integrated controller, disconnect the SCSI cable from the ServeRAID connector on the system board. See the label inside the server cover for the location of the ServeRAID connector. 5. Remove all other non-ServeRAID IDE and SCSI disk-storage adapters and controllers. Note If one of the disk-storage controllers that you need to remove is on the system board, you must do one of the following: If the CD-ROM drive that you are using to install the operating system is attached to the integrated disk-storage controller, disconnect or remove all disk drives attached to the integrated controller. If only disk drives are attached to the integrated controller, disconnect the cable for the integrated controller from the IDE or SCSI connector on the system board. See the label inside the server cover for the location of the IDE or SCSI controller connector. 6. Follow the instructions in "Installing the files while installing UnixWare" on page 150; then, return here and continue with step 7. 7. Power down the system. 148 Netfinity Server HMM