IBM 86624RY Maintenance Manual - Page 320

ServeRAID controller error codes/messages The error codes/messages are displayed on the screen in a line of text immediately after the controller BIOS version. If POST detects changes in the controller configuration or detects an controller hardware problem, messages appear on the screen. Refer to "ServeRAID POST error procedures" on page 314 and correct the problem. If there is no POST Error or Configuration Error message, the BIOS screen resembles the sample shown below. Please note that your version may be different from the one shown. IBM ServeRAID BIOS Copyright IBM Corp. 1995,1998 Ver: 3. .12 8/14/1998 «« Press Ctrl+I to access the Mini-Configuration Program. »» Initializing ServeRAID Controller 1 in Slot 1. Power-on self-test can take up to 59 Second(s) -- test Passed. Drive configuration can take up to 6 Minute(s) Second(s) -- test Passed. ServeRAID Firmware Version:2.82. No logical drives found; none are installed. Non-Disk SCSI Devices Found: CD-ROM , Tape , Removable-media , Other 1. BIOS not loaded no devices found - Installation stopped. If there is a POST Error message, the BIOS screen resembles the sample shown below. Refer to "ServeRAID POST error codes" on page 314 and correct the problem. The characters XXXX indicate the POST (ISPR) error. IBM ServeRAID BIOS Copyright IBM Corp. 1995,1998 Ver: 3. .12 8/14/1998 «« Press Ctrl+I to access the Mini-Configuration Program. »» Initializing ServeRAID Controller 1 in Slot 1. Power-on self-test can take up to 59 Second(s) -- test Failed. Controller is not responding properly - Run Diagnostics. Error Code: XXXX-YY BIOS not loaded no devices found - Installation stopped. The BIOS screen below shows Configuration Status and/or Error information. Refer to "ServeRAID Startup Messages" on page 318. 312 Netfinity Server HMM