IBM 86624RY Maintenance Manual - Page 154

2. Insert the ATAPI BTLD diskette when prompted; then, press r to replace the wd driver. The fields for the ATAPI CD-ROM are: Srom=wd(c,d,l,b) where: c = primary (0) or secondary (1) IDE/EIDE controller d = master (0) or slave (1) device l = LUN of device (always 0 with ATAPI or wd driver) b = BUS of device (always 0 with ATAPI or wd driver) Installing the files for OpenServer 5.0.2 and 5.0.4: To install files for OpenServer Versions 5.0.2 or 5.0.4 using an IDE CD-ROM drive: 1. Type the following at the BOOT prompt: restart link=ipsraid Srom=wd( , , , ) Note The ATAPI BTLD (which includes the wd driver) is included in OpenServer 5.0.2 and 5.0.4. The fields for the ATAPI CD-ROM are: Srom=wd(c,d,l,b) where: c = primary (0) or secondary (1) IDE/EIDE controller d = master (0) or slave (1) device l = LUN of device (always 0 with ATAPI or "wd" driver) b = BUS of device (always 0 with ATAPI or "wd" driver) 2. Let the system start normally until it comes to the select Media options. If you are using OpenServer 5.0.2, go to step 3. If you are using OpenServer 5.0.4, go to step 4. 3. To install with OpenServer 5.0.2: a. Select Adapter type as WD. b. Select Media Type as SCSI CD-ROM. c. Select ID, BUS and LUN as 0. d. Go to step 5. 4. To install with OpenServer 5.0.4: a. Select Media Type as IDE CD-ROM Drive. b. Select Primary Adapter and Master Device. c. Go to step 5. 5. You have completed the installation. Installing ServeRAID device drivers for UnixWare: The instructions for installing the ServeRAID files when using UnixWare depend on the number of IDE and SCSI disk-storage adapters and controllers installed in the system. If all of the direct-access-storage devices (DASD) 146 Netfinity Server HMM