IBM 86624RY Maintenance Manual - Page 160
ServerRAID background-server, components, Command-line parameters
UPC - 087944490654
View all IBM 86624RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
ipsadm & 3. Press Enter. If you are using Novell NetWare: 1. Load the remote component. To do this, type: load ipsadm.nlm 2. Press Enter Notes 1. To load the NetWare Administration program with NetWare SFT III installed, load IPSADM.NLM in the mirrored server engine. The ServeRAID adapters and controllers in the primary and backup servers will appear to the Administration and Monitoring Program as if they were in one server. 2. When a rebuild, synchronization, or logical-drive migration is in process, you cannot stop the IPSADM.NLM module by pressing the Esc key. To stop the module during one of these operations, you must unload the IPSADM.NLM module. ServerRAID background-server components This section provides information about background-server component command-line parameters and logging messages. Command-line parameters: To use the command-line parameters provided in the background-server components, issue the IPSADM command in the following format: IPSADM parameter 1 parameter 2 parameter 3 etc.... Valid command-line parameters for the background-server components are as follows: -? The -? command displays the help for the valid parameters. -p:number The -p:number command specifies the port number that the server will check for client connections. The port number is a parameter used in TCP/IP to distinguish among different services on a single server. The default for the server utility programs is port number 1087. You can use this parameter to change the port number if another service on the system is using 1087. 152 Netfinity Server HMM