IBM 86624RY Maintenance Manual - Page 232

a. If the drive is a half-high drive, remove the two screws 8 that hold the connector 7 to the hot-swap tray 5 ; then, remove the connector from the back of the drive. b. Remove the four screws 3 (for a half-high drive) or 4 (for a slim-high drive) that attach the drive 6 to the hot-swap tray, and remove the drive from the tray. 4. Place the new hard disk drive on the hot-swap tray and attach the drive to the tray using four screws, as follows: a. If the drive is a half-high drive, use screws 3 to attach the drive to the tray. If the drive is a slim-high drive, use screws in holes 4 to attach the drive to the tray. b. As you tighten each screw, press on the metal spring nearest the screw at the point indicated by the arrow on the illustration of the drive tray. c. If the drive is a half-high drive, plug the connector 7 to the back of the drive and secure the connector to the drive with screws 8 . (Slim-high drives do not need the connector.) 5. Install the hard disk drive in the hot-swap bay: a. Ensure the tray handle is open (that is, perpendicular to the drive). b. Align the drive/tray assembly so that it engages the guide rails in the bay. c. Push the drive assembly into the bay until the drive connects to the backplane. d. Push the tray handle to the right until it locks. 6. Check the hard disk drive status indicators to verify that the hard disk drive is installed properly. See "Status LEDs" on page 63 for details. 7. Close and lock the server door. 224 Netfinity Server HMM