IBM 86624RY Maintenance Manual - Page 188

2. Push the bottom of the bezel toward the server until the two tabs at the bottom of the bezel snap into place. To install the NetBAY3 bezel: 1. Hook the tabs on the left side of the NetBAY3 bezel 2 around the posts on the NetBAY3. 2. Gently push the right side of the bezel toward the server until the bezel snaps into place. 3. Lock the NetBAY3 bezel. To install the server front door: 1. Align the pins on the server door 1 with the hinges on the server and slide the door down. 2. Close and lock the door. Reconfiguring the server: When you start the server for the first time after you add or remove an internal option or an external SCSI device, you might see a message telling you that the configuration has changed. Some options have device drivers that you need to install. Refer to the documentation that comes with the option for information about installing any required device drivers. If you have more than one microprocessor installed, you might want to upgrade the operating system. If you have installed or removed hard disk drives, refer to "ServeRAID system board controller" on page 66 for information about reconfiguring the disk arrays. Run the Configuration/Setup Utility program to save the new configuration information. 180 Netfinity Server HMM