IBM 86624RY Maintenance Manual - Page 288

22 RS-485 termination jumper block (J26) 23 IDE connector (J33) 24 Disable Advanced System Management Processor jumper block (J51) 25 Fan connector (J36) 26 Diskette drive connector (J22) 27 Power-on password override jumper block (J24) 28 Flash ROM page swap jumper block (J30) 29 Information LED panel connector (J20) 3 Battery 31 Reserved (J46) 32 Hot-plug PCI controller programmer interface connector (J53) 33 ISA expansion slot 34 Hot-plug switch connector (J16) 35 PCI slot LEDs (four are on the side of the board) 36 PCI (hot-plug) slots 1-4 (on PCI primary bus 1) 37 PCI slots 5 and 6 (on PCI primary bus 0) Note: Because of the processor support tray, PCI slot 6 is not available for use and PCI slot 5 supports only a short adapter. 38 Parallel port connector (J56) (Serial port A and B connectors are below the parallel port connector.) 39 Video port connector (J2) 4 Management port C connector (J42) 41 USB 1 and USB 2 port connectors (J31) (USB 2 is below USB 1) 42 Mouse and keyboard connectors (J1) (The mouse connector is above the keyboard connector.) 43 Ethernet port connector (J4) 44 Reserved (J17) 45 Reserved (J18) 46 Disable Ethernet controller jumper block (J5) 47 Disable video controller jumper block (J14) System board jumpers Table 18 describes the jumpers on the system board. The numbers in the table correspond to the highlighted numbers on the illustration in "System board component locations" on page 279. Note Turn off the server and disconnect the power cords before moving any jumpers. Table 18 (Page 1 of 2). System board jumpers Jumper Name 8 J11 Disable RAID controller 9 J45 Reserved Description The default position is Enabled (jumper on pins 1 and 2). Move the jumper to pins 2 and 3 to disable the RAID controller. The default position is a jumper on pins 2 and 3. 280 Netfinity Server HMM