IBM 86624RY Maintenance Manual - Page 136
ServeRAID IPSMON program starting, Controller Options, Controller, Options
UPC - 087944490654
View all IBM 86624RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
HSREBUILD Use the HSREBUILD command to set the ServeRAID adapter or controller hot-swap rebuild feature on. Use a question mark (?) to display the current status of the hot-swap rebuild feature. Supported operating systems: Windows NT, OS/2, NetWare, OpenServer, UnixWare, and DOS Command: IPSSEND HSREBUILD Controller Options Replace: Controller with the ServeRAID controller number (1 to 8) Options with ON to enable the hot-swap rebuild feature, or ? to display the status of the hot-swap rebuild feature. ServeRAID IPSMON program (starting) You can run the IPSMON program from the operating system command line. To start the IPSMON program: If you are using OS/2 or Windows NT: 1. Type: c:\ipsadm\ipsmon 2. Press Enter. Note The c represents the drive where OS/2 or Windows NT is installed. If you are using Novell NetWare: 1. From the console, type: load ipsmon 2. Press Enter. If you are using SCO OpenServer or UnixWare: 1. Type: /usr/bin/ipsmon 2. Press Enter. ServeRAID IPSMON program (using) When you start this monitoring program, it immediately begins polling all ServeRAID adapters and controllers for specific conditions. If a condition being monitored is found, this program logs a message to the monitor, to a file, or to both the monitor and a file. The IPSMON program uses command-line parameters to determine where to log the messages. If you need help, you can type the IPSMON -? command for a list of valid parameters. 128 Netfinity Server HMM