IBM 86624RY Maintenance Manual - Page 67

To use Remote Video Mode to monitor and access POST on the server: 1. Use a terminal program to establish a connection with the Netfinity Advanced System Management Processor modem. 2. Log in to the Netfinity Advanced System Management Processor. When you have established a connection with the Netfinity Advanced System Management Processor, you will be prompted for a username and password. You must provide a username and password combination that has been previously configured for use with the Netfinity Advanced System Management Processor. You can use one of two username and password combinations: The default username (USERID) and password (PASSW0RD) Note The default username and password is case sensitive. You must use all caps, and the "0" in PASSW0RD, is the numeral zero. A username and password that you define using the Advanced System Management service and Netfinity Manager Important If you update the Netfinity Advanced System Management Processor microcode, the default username (USERID) and password (PASSW0RD) are reset. If applicable, notify the system administrator. When you have logged into the Netfinity Advanced System Management Processor, the following main menu appears: 2 Monitors 3 Error Logs 4 Service Processor Configuration 5 System Services 6 System Power 7 Boot B Remote Terminal Status Y Disconnect Current Logon Z Start Remote Video 3. Start (or restart) the server. If the remote server is currently powered off: a. Select 6 System Power from the main menu. b. Select 4 Power On from the System Power menu. If the server is currently powered on, you must restart the server. You can use selections from Netfinity 5500 M20 - Type 8662 59