IBM 86624RY Maintenance Manual - Page 228
Installing a drive in a hot-swap bay, Preinstallation steps all bays
![]() |
UPC - 087944490654
View all IBM 86624RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
Installing a drive in a hot-swap bay: The bays on the right front of the server support hot-swap drives only. Note You do not have to turn off the server to install hot-swap drives in these bays. However, you must turn off the server when performing any steps that involve installing or removing cables. Note Read "Safety information" on page 340. Read the documentation that comes with the drive. Review "ServeRAID system board controller" on page 66 for information about the RAID controller and disk-array configuration. Prepare the drive for installation (see "Preinstallation steps (all bays)" on page 216). Refer to the following illustration while you perform the steps in this procedure. 1 Filler panel 2 Hot-swap hard disk drive 3 Drive tray handle (open position) To install a drive in a hot-swap bay: 1. Unlock and open the server door (see "Preparing to install options" on page 246). 220 Netfinity Server HMM
![](/manual_guide/products/ibm-86624ry-maintenance-manual-8d18aa9/228.png)