Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 103

Transition Networks SISPM1040-3xxx-L Web User Guide 6-9 Port Isolation Port Isolation provides for an apparatus and method to isolate ports on layer 2 switches on the same VLAN to restrict traffic flow. The apparatus comprises a switch having said plurality of ports, each port configured as a protected port or a non-protected port. An address table memory stores an address table having a destination address and port number pair. A forwarding map generator generates a forwarding map which is responsive to a destination address of a data packet. The method for isolating ports on a layer 2 switch comprises configuring each of the ports on the layer 2 switch as a protected port or a non-protected port. A destination address on a data packet is matched with a physical address on said layer 2 switch and a forwarding map is generated for the data packet based upon the destination address on the data packet. The data packet is then sent to the plurality of ports pursuant to the forwarding map generated based upon whether the ingress port was configured as a protected or non-protected port. This page is used for enabling or disabling port isolation on ports in a Private VLAN.A port member of a VLAN can be isolated to other isolated ports on the same VLAN and Private VLAN. Web Interface To configure Port Isolation parameters in the web interface: 1. Click VLAN Management and Port Isolation. 2. Check the port(s) on which you want to enable Port Isolation. 3. Click Apply. Figure 6-9: Port Isolation Configuration Parameter descriptions: Port Members : A check box is provided for each port of a private VLAN. When checked, port isolation is enabled on that port. When unchecked, port isolation is disabled on that port. By default, port isolation is disabled on all ports. Buttons Apply : Click to save changes. Reset : Click to undo any changes made locally and revert to previously saved values. 33763 Rev. G https://www.transition.com Page 103 of 496