Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 59

Transition Networks SISPM1040-3xxx-L Web User Guide 4-5.3 LACP Configuration This page lets you view and configure the current LACP port parameters. Note that LACP and Static aggregation cannot both be enabled on the same ports at the same time. Web Interface To configure the LACP Port Configuration in the web UI: 1. Click Port Management, Link Aggregation and LACP Configuration. 2. Enable or disable LACP on the desired switch ports. 3. Select the Key parameter (Auto or Specific). The default is Auto. 4. Select the Role of Active or Passive. The default is Active. 5. Click Apply to save the settings. 6. To cancel the settings click the reset button. It will revert to previously saved values. Figure 4-5.2: LACP Port Configuration Parameter descriptions: Port : The switch port number. LACP Enabled : Controls whether LACP is enabled on this switch port. LACP will form an aggregation when 2 or more ports are connected to the same partner. Key : The Key value incurred by the port, range 1-65535. The Auto setting will set the key as appropriate by the physical link speed, 10Mb = 1, 100Mb = 2, 1Gb = 3. Using the Specific setting, a user-defined value can be entered. Ports with the same Key value can participate in the same aggregation group, while ports with different keys cannot. Role : The Role shows the LACP activity status. The Active will transmit LACP packets each second, while Passive will wait for a LACP packet from a partner (speak if spoken to). 33763 Rev. G https://www.transition.com Page 59 of 496