Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 38

Transition Networks SISPM1040-3xxx-L Web User Guide 3-4.4 LLDP-MED Neighbor This page provides a summary of all LLDP-MED neighbors. The displayed table contains a row for each interface on which an LLDP neighbor is detected. This function applies to VoIP devices which support LLDP-MED. If no LLDP-MED device is found in your network, the table displays "No LLDP-MED neighbor information found". To show LLDP-MED neighbor information: 1. Click System, LLDP, and LLDP-MED Neighbor. 2. Click Refresh to immediately update the page. 3. Click Auto-refresh to automatically update the page every 3 seconds. Figure 3-4.4: LLDP-MED Neighbor information Parameter descriptions: Port : The interface on which the LLDP frame was received. Device Type : LLDP-MED Devices are comprised of two primary Device Types: Network Connectivity Devices and Endpoint Devices. LLDP-MED Network Connectivity Device Definition: LLDP-MED Network Connectivity Devices, as defined in TIA1057, provide access to the IEEE 802 based LAN infrastructure for LLDP-MED Endpoint Devices. An LLDP-MED Network Connectivity Device is a LAN access device based on any of these technologies: 1. LAN Switch/Router 2. IEEE 802.1 Bridge 3. IEEE 802.3 Repeater (included for historical reasons) 4. IEEE 802.11 Wireless Access Point 5. Any device that supports the IEEE 802.1AB and MED extensions defined by TIA-1057 and can relay IEEE 802 frames via any method. LLDP-MED Endpoint Device Definition: LLDP-MED Endpoint Devices, as defined in TIA-1057, are located at the IEEE 802 LAN network edge, and participate in IP communication service using the LLDP-MED framework. Within the LLDP-MED Endpoint Device category, the LLDP-MED scheme is broken into further Endpoint Device Classes, as defined in the following. Each LLDP-MED Endpoint Device Class is defined to build upon the capabilities defined for the previous Endpoint Device Class. For-example will any LLDP-MED Endpoint Device claiming compliance as a Media Endpoint (Class II) also support all aspects of TIA-1057 applicable to Generic Endpoints (Class I), and any LLDP-MED Endpoint Device claiming compliance as a Communication Device (Class III) will also support all aspects of TIA-1057 applicable to both Media Endpoints (Class II) and Generic Endpoints (Class I). 33763 Rev. G https://www.transition.com Page 38 of 496