Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 148

Transition Networks SISPM1040-3xxx-L Web User Guide 9-2 Port Policers This page provides an overview of QoS Ingress Port Policers for all switch ports The Port Policing is useful in constraining traffic flows and marking frames above specific rates. Policing is primarily useful for data flows and voice or video flows because voice and video usually maintains a steady rate of traffic Web Interface To configure the QoS Port Policers in the web UI: 1. Click Quality of Service and Port Policers. 2. Click which port(s) on which you want QoS Ingress Port Policers enabled. 3. Set the Rate, Unit, and Flow Control parameters. 4. Click Apply to save the settings. 5. To cancel the settings click the Reset button. It will revert to previously saved values. Figure 9-2: QoS Ingress Port Policers Configuration Parameter descriptions: Port : The logical port for the settings contained in the same row. Enabled : Check the box for the Port(s) on which you want to enable the QoS Ingress Port Policers function. Rate : To set the Rate limit value for this port, the default is 50000. Unit : Controls the unit of measure for the port policer rate as kbps, Mbps, fps or kfps. The default is kbps. 33763 Rev. G https://www.transition.com Page 148 of 496