Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 372
React On Link Change
View all Lantronix SISPM1040-3166-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 372 highlights
Transition Networks SISPM1040-3xxx-L Web User Guide VLAN ID: The VLAN ID assigned to the MRP protocol. The allowed range is 0 to 4094. Manager Priority: This parameter contains the value for the manager priority. Check Media Redundancy: This parameter selects whether monitoring of MRM state is enabled or disabled. Only MRM. Topology Change Interval, ms: This parameter contains the value of the interval for sending MRP_TopologyChange frames. The allowed range is 1 to 20. Only MRM. Topology Change Repeat Count: This parameter contains the value of the interval count which controls repeated transmissions of MRP_TopologyChange frames. The allowed range is 1 to 5. Only MRM. Default Test Interval, ms: This parameter contains the value of the default interval for sending MRP_Test frames on ring ports. The allowed range is 1 to 50. Only MRM. Short Test Interval, ms: This parameter contains the value of the short interval for sending MRP_Test frames on ring ports after link changes in the ring. The allowed range is 1 to 30. Only MRM. Test Monitoring Count: This parameter contains the value of the interval count for monitoring the reception of MRP_Test frames. The allowed range is 1 to 15. Only MRM. Test Monitoring Extended Count: This optional parameter contains the value of the extended interval count for monitoring the reception of MRP_Test frames. The allowed range is 1 to 30. Only MRM. Non-Blocking MRC Supported: This parameter specifies the ability of the MRM to support MRCs without BLOCKED port state support in the ring. Only MRM. React On Link Change: This optional parameter specifies whether the MRM reacts on MRP_LinkChange frames or not. Only MRM. Link Down Interval, ms: This parameter contains the value of the interval for sending MRP_LinkDown frames on ring ports. The allowed range is 1 to 50. Only MRC. Link Up Interval, ms: This parameter contains the value of the interval for sending MRP_LinkUp frames on ring ports. The allowed range is 1 to 50. Only MRC. Link Change Count: This parameter contains the value of the MRP_LinkChange frame count which controls repeated transmissions of MRP_LinkUp or MRP_LinkDown frames. The allowed range is 1 to 10. Only MRC. BLOCKED State Supported: This parameter specifies whether the MRC supports BLOCKED state at its ring ports. Only MRC. Buttons Apply: Click to save changes. Reset: Click to undo any changes made locally and revert to previously saved values. Messages: Ring port is used The name is used with other domain 33763 Rev. G https://www.transition.com Page 372 of 496