Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 390

Transition Networks SISPM1040-3xxx-L Web User Guide Trap Mode : Indicates the SNMP mode operation. Possible modes are: Disabled: Disable SNMP mode operation. UDP: Use UDP as the SNMP mode operation. TCP: Use TCP as the SNMP mode operation. Trap Version : Indicates the SNMP supported version. Possible versions are: SNMP v1: Set SNMP supported version 1. SNMP v2c: Set SNMP supported version 2c. SNMP v3: Set SNMP supported version 3. Trap Community : Indicates the community access string when sending SNMP trap packet. The allowed string length is 0 to 63 characters, and the allowed content is ASCII characters from 33 to 126. Trap Destination Address : Indicates the SNMP trap destination address. It allows a valid IP address in dotted decimal notation ('x.y.z.w'). It also allows a valid hostname. A valid hostname is a string drawn from the alphabet (A-Za-z), digits (0-9), dot (.), dash (-). Spaces are not allowed, the first character must be an alpha character, and the first and last characters must not be a dot or a dash. Indicates the SNMP trap destination IPv6 address. IPv6 address is in 128-bit records represented as eight fields of up to four hexadecimal digits with a colon separating each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a special syntax that can be used as a shorthand way of representing multiple 16-bit groups of contiguous zeros; but it can appear only once. It can also represent a legally valid IPv4 address. For example, '::192.1.2.34'. Trap Destination port : Indicates the SNMP trap destination port. SNMP Agent will send SNMP message via this port, the port range is 1~65535. Trap Security Engine ID : Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs using USM for authentication and privacy. A unique engine ID for these traps and informs is needed. When "Trap Probe Security Engine ID" is enabled, the ID will be probed automatically. Otherwise, the ID specified in this field is used. The string must contain an even number (in hexadecimal format) with number of digits between 10 and 64, but all-zeros and all-'F's are not allowed. Trap Security Name : Indicates the SNMP trap security name. SNMPv3 traps and informs using USM for authentication and privacy. A unique security name is needed when traps and informs are enabled. Buttons Add New Entry : Click to add a new entry. Apply : Click to save changes. After saving configuration, remember to select the correct trap security name. Reset : Click to undo any changes made locally and revert to previously saved values. After you click Apply to save the changes, the page displays with the Trap Destination Configurations table as shown and described below. 33763 Rev. G https://www.transition.com Page 390 of 496