Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 284

Transition Networks SISPM1040-3xxx-L Web User Guide 2) Make a Port Security configuration change on the port. 3) Boot the switch. Violation Limit : The maximum number of MAC addresses that can be marked as violating on this port. This number cannot exceed 1023. Default is 4. It is only used when Violation Mode is Restrict. State : This column shows the current state of the port as seen from the Limit Control's point of view. The state takes one of four values: Disabled: Limit Control is either globally disabled or disabled on the port. Ready: The limit is not yet reached. This can be shown for all actions. Limit Reached: Indicates that the limit is reached on this port. This state can only be shown if Action is set to none or Trap. Shutdown: Indicates that the port is shut down by the Limit Control module. This state can only be shown if Action is set to Shutdown or Trap & Shutdown. Re-open button : If a port is shut down by this module, you may reopen it by clicking this button, which will only be enabled if this is the case. For other methods, refer to Shutdown in the Violation Mode section. Note that clicking the Reopen button causes the page to be refreshed, so non-committed changes will be lost. Sticky : If running config has sticky MAC addresses, then these MAC addresses are automatically to be static MAC addresses on the MAC table. Clear : To clear the static MAC addresses added by the sticky function. Buttons Apply : Click to save changes. Reset : Click to undo any changes made locally and revert to previously saved values. 33763 Rev. G https://www.transition.com Page 284 of 496