Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 194

Transition Networks SISPM1040-3xxx-L Web User Guide Parameter descriptions: Aging Configuration: By default, dynamic entries are removed from the MAC table after 300 seconds. This removal is also called aging. Configure aging time by entering a value here in seconds; for example, Age time seconds. The allowed range is 10 to 1000000 seconds. Disable the automatic aging of dynamic entries by checking Disable automatic aging. MAC Table Learning: If the learning mode for a given port is greyed out, another module is in control of the mode, so that it cannot be changed by the user. An example of such a module is the MAC-Based Authentication under 802.1X. Each port can do learning based upon the following settings: Auto : Learning is done automatically as soon as a frame with unknown SMAC is received. Disable : No learning is done. Secure : Only static MAC entries are learned; all other frames are dropped. NOTE: Make sure that the link used for managing the switch is added to the Static Mac Table before changing to Secure learning mode, otherwise the management link is lost and can only be restored by using another non-secure port or by connecting to the switch via the serial interface. VLAN Learning Configuration Learning-disabled VLANS : This field shows the Learning-disabled VLANs. When a NEW MAC arrives into a learning-disabled VLAN, the MAC won't be learnt. By the default, the field is empty. More VLANs may be created by using a list syntax where the individual elements are separated by commas. Ranges are specified with a dash separating the lower and upper bound. The following example will create VLANs 1, 10, 11, 12, 13, 200, and 300: 1,10-13,200,300. Spaces are allowed in between the delimiters. Static MAC Table Configuration: The static entries in the MAC table are shown in this table. The static MAC table can contain 128 entries. VLAN ID : The VLAN ID of the entry. MAC Address : The MAC address of the entry. Port Members : Checkmarks indicate which ports are members of the entry. Check or uncheck as needed to modify the entry. Buttons Add New Static Entry : Click to add a new entry to the static MAC table. Specify the VLAN ID, MAC address, and port members for the new entry. Click "Apply". Delete : Check to delete the entry. It will be deleted immediately. Apply : Click to save changes. Reset : Click to undo any changes made locally and revert to previously saved values. Message: Error: mac address:00-00-00-00-00-00 is not multicast mac address, support only one port. 33763 Rev. G https://www.transition.com Page 194 of 496