Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 467

Transition Networks SISPM1040-3xxx-L Web User Guide Monitor Console: Displays the traffics for device health check purpose. • For each IP device except DMS switches, User can set a threshold of throughput for IP devices, and get notification when throughput is lower or higher than settings. • If both values are "0", it means the function is disabled. • Polling interval is 1 second, when the page is closed, the Polling interval will change to around 5 seconds. PoE Auto Checking "AutoFill" Feature When you enable Auto power reset (PoE auto checking) in DMS, the IP addresses of the connected devices are automatically filled on the Auto Power Reset configuration page. 1. Configure the "PoE Auto Checking" parameter at Switch > PoE Management > PoE Auto Checking. The default value of the "Failure Action" parameter is "Reboot Remote PD". Note that "PoE Auto Checking" is called "PoE Auto Power Reset" in earlier firmware versions. 2. Configure PoE parameters at DMS > Graphical Monitoring > Topology View. Left click on the switch icon to display its device configuration popup. Click the PoE Config ( pane: ) icon to display the PoE Auto Checking 33763 Rev. G https://www.transition.com Page 467 of 496