Lantronix SISPM1040-3166-L Web User Guide Rev G PDF 14.13 MB - Page 252
Web Interface, Access Method Configuration, Parameter descriptions, Delete, VLAN ID,
![]() |
View all Lantronix SISPM1040-3166-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 252 highlights
Transition Networks SISPM1040-3xxx-L Web User Guide 15-1.4 Access Method This page lets you configure switch access method parameters, including HTTP/HTTPS, SNMP, and TELNET/SSH. You can manage the switch over an Ethernet LAN, or over the Internet. The maximum number of entries is 16. If the application's type matches any one of the access management entries, it will allow access to the switch. Web Interface To configure Access Method parameters in the web UI: 1. Click Security, Management and Access Method. 2. Select "on" in the Mode of Access Management Configuration. 3. Click "Add New Entry". 4. Specify the VLAN ID, Start IP Address, End IP Address. 5. Check Access Management method (HTTP/HTTPS, SNMP, and TELNET/SSH) in the entry. 6. Click Apply. Figure 15-1.4: Access Method Configuration Parameter descriptions: Mode : Indicates the access management mode operation. Possible modes are: on : Enable access management mode operation. off : Disable access management mode operation. Delete : Check to delete the entry. It will be deleted immediately. VLAN ID : Indicates the VLAN ID for the access management entry. Start IP address : Indicates the start IP unicast address for the access management entry. End IP address : Indicates the end IP unicast address for the access management entry. HTTP/HTTPS : Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP address matches the IP address range provided in the entry. 33763 Rev. G https://www.transition.com Page 252 of 496
![](/manual_guide/products/lantronix-sispm10403166l-web-user-guide-rev-g-pdf-1413-mb-66b08af/252.png)