Sony PDWHD1500 User Manual (PDW-HD1500 / F1600 Operation Manual for Firmware V - Page 132
Digital Audio Pb Process On, Analog Audio Edit Preset
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Menu items in the 300s, relating to editing operations Item number Item name 317 [F1600] AUDIO EDIT MODE Settings Select the type of audio transition used for linear editing. cut edit: Cut editing (audio discontinuity at transition point, and possible noise during playback). cross fade: Cross-fade 320 DIGITAL AUDIO PB PROCESS ON Specify the handling of audio at edit points and at the second and EDIT POINT subsequent recording start points in Clip Continuous Rec recording. cut: Carry out a cut (possibly resulting in audio discontinuities at the edit point). fade: Fade out and fade in. 329 [F1600] Select methods for setting the edit presets of the digital audio channels ANALOG AUDIO EDIT PRESET CH5 to CH8 of this unit. Make these settings when using an editor REPLACE FOR CH5 (PVE-500, BVE-600, etc.) or remote control unit without a function to 330 [F1600] ANALOG AUDIO EDIT PRESET REPLACE FOR CH6 control digital audio edit presets. The edit presets of the digital audio channels of this unit are turned on and off according to the specified analog audio presets of the editor or remote control unit. 331 [F1600] nodef (no definition): No definition ANALOG AUDIO EDIT PRESET ch 1 (analog ch1): Follow the edit preset of analog channel 1. REPLACE FOR CH7 ch 2 (analog ch2): Follow the edit preset of analog channel 2. 332 [F1600] ANALOG AUDIO EDIT PRESET ch1+2 (analog ch1+ch2): Follow the edit preset of analog channel 1 or 2. REPLACE FOR CH8 344 ASSEMBLE AUTO EDIT Set whether to record 2 seconds of postroll when an additional clip is POSTROLL RECORDING recorded by sending the AUTO EDIT command (9-pin protocol 20·42) from a nonlinear editing system connected to the REMOTE(9P) connector on the rear panel. Note When using a linear editing system, postroll will not be recorded regardless of this setting. off: Do not record postroll. on: Records approximately 2 seconds of postroll. Menu items in the 400s, relating to preroll Item number Item name Settings 401 FUNCTION MODE AFTER CUE-UP Select the state that the unit goes into after a cuing-up operation. stop: Stops (the stop mode). still: Still playback (in jog and shuttle mode). Item number Item name 501 STILL TIMER Menu items in the 500s, relating to disc protection Settings To protect the disc against shock and vibrations, and to lengthen the life of the laser diodes, the unit automatically enters standby off mode whenever a specified time elapses in a disc stop mode (stop mode or the still picture mode of search mode). This allows you to set the time after which the unit exits a disc stop mode and enters standby off mode. 0.5 s (0.5 sec)... 8 m (8 min)... 30 m (30 min): Can be set in the range from 0.5 seconds to 30 minutes. off: Do not put into standby off mode. Chapter 7 Menus 132 Setup Menu