Sony PDWHD1500 User Manual (PDW-HD1500 / F1600 Operation Manual for Firmware V - Page 32
Preparations, Preparing Power Sources, Supplying power, Attaching a battery pack
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Preparations 3 Chapter Chapter 3 Preparations Preparing Power Sources This unit can be powered by AC power, DC power, or a battery pack. For safety, use only the Sony battery packs listed below. Lithium-ion battery pack: BP-L80S, BP-GL95 Note If you load or remove a battery pack incorrectly, it may fall and cause bodily injury. Follow the procedures described below to load or remove them. Supplying power AC power supply Connect the AC IN connector to an AC power source using the specified AC power cord. To supply AC power to the unit, set the on/standby button on the front panel to ON and the POWER switch on the rear panel to = (ON). DC power supply Connect the DC IN 12V connector to a DC power source. To supply DC power to the unit, set the on/standby button on the front panel to ON and the POWER switch on the rear panel to OFF. If the POWER switch on the rear panel is set to = (ON), AC power is supplied. Continuous recording time at room temperature BP-GL95 lithium-ion battery pack: 80 minutes (95 minutes when used in power save mode) For details on charging battery packs, refer to the operation manual for the battery charger. Notes about battery usage • Before using the batteries, be sure to charge them fully with the special battery charger. Refer to the operating instructions for your battery charger for more information about how to charge the batteries. • Batteries may not be completely charged if you charge them immediately after use when they are still warm. You should wait until the batteries cool before charging them. Attaching a battery pack Attaching and removing of the BP-GL95 Battery Pack is described below. The BP-L80S can also be attached and removed in the same way. For details on attaching the BKP-L551, refer to the installation manual for the BKP-L551. 1 Attach the BKP-L551 to the side panel. Battery power supply Battery packs that can be used with this unit are as follows. To use battery pack, a BKP-L551 Battery Adaptor and a BC-L100 Battery Charger are also required. • BP-L80S • BP-GL95 BKP-L551 2 Align the grooves on the BP-GL95 with the projections on the BKP-L551. 32 Preparing Power Sources