Sony PDWHD1500 User Manual (PDW-HD1500 / F1600 Operation Manual for Firmware V - Page 60
Connections, Preparations for editing, Editable video and audio signals, Discs that can be used
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Chapter 4 Recording and Playback • MPEG IMX 59.94i/50i • DVCAM 59.94i/50i Note Editing of the MPEG HD420 format is not supported. Editable video and audio signals This unit supports editing of the following signals on video and audio tracks. • Video - HD-SDI (for HD recording) - SD-SDI (for SD recording) • Audio - SDI - Analog - AES/EBU Notes • Video and audio signals input to the (i.LINK) S400 connector cannot be edited. • Editing cannot be done with a File Access Mode (FAM) connection. • Recording of upconverted SD is not supported. Discs that can be used Use the following Professional Discs. Model number Capacity PFD23A PFD50DLA 23.3 GB 50.0 GB Data transfer rate (writing) 2.4 times normal Note A PFD23 Professional Disc with a 2 times normal data transfer rate cannot be used for linear editing. Connections Make connections in the same way as for a cut editing system (see page 37). When making the connections, also refer to the operation manuals provided with the equipment to be connected. Preparations for editing Recording format settings Before performing clip editing, you need to set the recording format of the PDW-F1600 units to match the recording format of the editing target clip. The following table shows the required settings. Item Recording format Audio/Non-audio (data) Setting Check the recording format of the clip with the display window (see page 24) and select the same format with setup menu item 031 RECORDING FORMAT. To perform insert editing of non-audio (data), set maintenance menu item M37: AUDIO CONFIG >M372: NONAUDIO INPUT to "data". Notes • When you insert non-audio into a clip, the channels containing the nonaudio are treated as non-audio across their entire length. • Use channel pairs (CH1/2, CH3/4, CH5/6, CH7/8) for non-audio insert editing. Non-audio editing is not executed unless a channel pair is specified. See page 126 for more information about setup menu operations. See page 148 for more information about maintenance menu operations. Settings required for editing The following table shows the settings required for editing. Item Setting Audio digital signal With the maintenance menu item M39: processor OTHER CONFIG >M393: AUDIO DSP, select "linear edit". Video input signal Select the video input signal with V INPUT on page P1 VIDEO of the function menu. Audio input signal Select the audio input signal with A1 INPUT and A2 INPUT on page P2 AUDIO, and A3 INPUT to A8 INPUT on page P3 AUDIO of the function menu. Input audio level Adjust the input audio level with the CH-1/ALL CH and CH-2 to CH-4 knobs. Edit point transition With setup menu item 317 AUDIO type EDIT MODE, select "cut edit" or "cross fade". Audio mix See the next section "To set up mixing of audio input signals". Time code • With TCG on page P5 TC of the function menu, select "INT". • With PRST/RGN on page P5 TC of the function menu, select "PRESET". • With RUN MODE on page P5 TC of the function menu, select "FREE RUN". 60 Linear Editing