Brother International BAS-411 Instruction Manual - English - Page 164

2 , , .es 4 ' n , 1 Can-'t edit Data T. Length larger Area Over Arrangement Err . 1. Some of data entered in communication mode has items that cannot edit. 2. Some of data entered in sewing mode while reading data has items that cannot edit. 3. According to editing item, there is item that cannot be set. £ e. r ° f',1 ' 0 t s,' p .t a Refer to page 57 Entered value exceeds maximum area (450 mm x 285 mm). Re-edit data. Improper area setting Re-set area or re-edit data. Value set in arrangement mode by [Each] is incorrect (ex. spaces ---- i I are inputted) or not all values are inputted. (ex. base line, base point.) Refer to page 83-101 "Arranging." 1.,.1. . 1. iLq , No inptted Data Short of Area **th Data ERR **th Memory OVR Area over B. Thread empty Thread breakage Over load g % , e a ° Without sewing data entered, you try to set machine to sewing mode. ? ¢ ° ; .1) . '' . ,, .. ,s ? ' i. ..4„4, First, input sewing data, then start sewing. Improper area setting Re-set area or re-edit data. Entered data has something wrong. Check where data was made, then contact your dealer. Too much data, or number of inputted stitches is over inside memory capacity and cannot manage it. If memory expansion board (optional) is not set, set memory expansion board or decrease input data. When sewing starts from current needle position, sewing pattern is over the area. Move hoop to position where. message disappears, or widen area. Set sewing times in bobbin thread Re-set sewing times in bobbin counter is completed. thread counter. 1. Needle thread breakage 2. Needle thread is not passed through the thread sensor spring. 3. Bobbin thread breakage 4. Bobbin thread runs out. Pass thread. 1. Pulley is too tight. 2. Electrical failure Remove load. Contact your dealer. -160-