Brother International BAS-411 Instruction Manual - English - Page 37
turning, power, machine
View all Brother International BAS-411 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
A C] When turning on the power of the machine [NOTE] When the needle bar and the pulley are not in the stop position or if even one of the needle thread takeups is not in line, lift the needle thread take-up with a finger. The needle thread take-ups form a l ine by the movement of the stopper. 1. If the following are displayed (1) N. Case POS ,ERR Set NC in order This message shows that the needle bar case is not aligned with the needle hole of the needle plate. The machine cannot operate if this occurs. needle bar case side 1. First of all, check that the needle bar stop position is correct. When the red mark @ of the clutch knurl 0 is on the side of the needle bar case, it is in the automatic jump condition. This is the normal position. 2. Turn the shaft@ slowly. If it is unusually heavy or does not turn, the needle thread take-up 0 or the needle bar is not in the proper position. Check again and adjust it. [NOTE] Do not turn the shaft forcefully. 3. When the needle bar case comes to the proper position, in the middle of the undetected area where the needle bar case does not move although the shaft @ is turned, the buzzer sounds 'beep' and the messages, "CAUTION MOVING!" and "Press START key" are alternately displayed. -33-