HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 113
Table 3-23, Compaq System Configuration Utility r Settings, for Booting into Compaq Utilities
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
3-56 Diagnostic Tools Table 3-23 Compaq System Configuration Utility Pager Settings for Booting into Compaq Utilities Pager Data Pager status Setting Enabled Description Indicates if the pager feature is enabled or disabled. Pager dial string ATDT 555-5555 Indicates the pager dial string and delay before the pager message. Pagers typically use one of the following formats: Local pagers: ATDT 555-5555 Wide area pagers: ATDT 1-800-555-5555,1234567# Pager message 1234567# Represents a unique number (maximum seven digits, numeric only) that you must designate to identify the server on your pager display. The ROM adds a three-digit code to the front of this number. The first two indicate the subsystem and the third indicates the severity of the error that caused the alert. The # symbol usually terminates the message. If no message is required, delete the # symbol. Pager test Select to test pager setup Use this to test the current pager settings. Press Enter to dial the pager number, and the pager message (if present) displays. You must configure the computer before testing the pager and the Pager Status must be set to Enabled. Do not test the pager if you are running remotely and are using only one modem. Serial interface COM1 Select the communications port for the modem used by the pager and the remote ASR-2 functions. The options are COM1 and COM2. Dial-in status Enabled Set Dial-In Status to Enabled. Be sure the Reset Boot option is set to Boot Compaq Utilities. When the system starts because of an ASR reset, it starts to the Compaq Utilities, sets the Management Modem to auto-answer, and waits for the administrator to dial in and run the Compaq Utilities. You automatically disable this option when you configure the software error recovery start option to Boot Operating System. When ASR pages you, you cannot dial in unless ASR-2 exceeds 10, the threshold number of server restart retries. When this happens, ASR-2 restarts the server into the Compaq Utilities and places the modem in auto-answer mode. Continued