HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 21
Front Fixed Bezel, Remove the seven T-15 screws securing the front fixed bezel to the chassis.
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2-8 Removal and Replacement Procedures Front Fixed Bezel The front fixed bezel must be removed to replace the power switch. To remove the front fixed bezel (tower model only): 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Open the front bezel door. 3. Remove the seven T-15 screws securing the front fixed bezel to the chassis. 4. Pull the front fixed bezel away from the chassis. COMPACT Figure 2-4. Removing the front fixed bezel NOTE: Drive cage may not be as illustrated. Reverse steps 1 through 4 to replace the front fixed bezel.
2-8
Removal and Replacement Procedures
Front Fixed Bezel
The front fixed bezel must be removed to replace the power switch. To remove the front
fixed bezel (tower model only):
1.
Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2.
Open the front bezel door.
3.
Remove the seven T-15 screws securing the front fixed bezel to the chassis.
4.
Pull the front fixed bezel away from the chassis.
Figure 2-4. Removing the front fixed bezel
NOTE
:
Drive cage may not be as illustrated.
Reverse steps 1 through 4 to replace the front fixed bezel.