HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 54
System I/O Board with Subpan
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
2-41 System I/O Board with Subpan The system I/O board with subpan is removed for replacement or to upgrade to a different Compaq model server. To remove the system I/O board with subpan: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the side access panel. See "Side Access Panel" earlier in this chapter. 3. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 4. Disconnect and remove all boards from the system I/O board. Place these boards on a nonconductive work surface. 5. Disconnect all cables from the system I/O board. 6. Loosen the thumbscrews securing the system I/O board and subpan to the chassis. 7. Move the system I/O board forward slightly, then up through the top of the server. Figure 2-37. Removing the system I/O board with subpan Reverse steps 1 through 7 to replace the system I/O board with subpan. Change the switch 1 and switch 2 settings to match the switch settings on the board being replaced. Install all removed boards onto the replacement system I/O board after installing the I/O board into the system. Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide