HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 66
Run the System Configuration Utility, For integrated SCSI Controllers
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
3-9 POST Error Messages Continued Error Code Audible Beeps L=Long S=Short Probable Source of Problem 1702-SCSI cable error detected. System halted. None Incorrect cabling. Recommended Action 1. For integrated SCSI Controllers, ensure that the internal connector has SCSI termination attached. 2. For option card SCSI controllers, ensure that only one of the two internal connectors has termination attached. 1703-SCSI cable error detected. Internal SCSI cable not attached to system board connector. System halted. None Incorrect cabling. Ensure that the integrated SCSI controller has SCSI termination attached. 1704-Unsupported Virtual Mode Disk Operation. DOS Driver Required. System halted. None System attempted to perform a Use fixed-disk device driver that virtual mode disk operation supports virtual mode memory services. without virtual mode memory services. 1705-Locked SCSI Bus Detected. System halted. None SCSI bus failure. Run Diagnostics. Replace failed assembly as indicated. 1730-Fixed Disk 0 does not support DMA Mode. None Fixed disk drive error. Run the System Configuration Utility and correct. 1731-Fixed Disk 1 does not support DMA Mode. None Fixed disk drive error. Run the System Configuration Utility and correct. 1740-Fixed Disk 0 failed Set Block Mode command None Fixed disk drive error. Run the System Configuration Utility and correct. 1741-Fixed Disk 1 failed Set Block Mode command None Fixed disk drive error. Run the System Configuration Utility and correct. 1750-Fixed Disk 0 failed Identify command None Fixed disk drive error. Run the System Configuration Utility and correct. Continued Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide