HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 24
U-Channel Access Panel,
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
2-11 U-Channel Access Panel The U-channel access panel is removed for replacement only. To remove the U-channel access panel: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Pull the drive cage assembly forward until it clears the front edge of the U-channel access panel. See "Drive Cage Assembly" later in this chapter. 3. Remove the caster mounting support. See "Caster Mounting Support" earlier in this chapter. 4. Remove the two T-15 screws securing the U-channel access panel to the chassis. 5. Slide the U-channel access panel forward, then pull it away from the chassis. Figure 2-7. Removing the U-channel access panel Reverse steps 1 through 5 to replace the U-channel access panel. Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide