HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 52
Power Supply Blank Panel, Pull the power supply cover plate away from the chassis.
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
2-39 Power Supply Blank Panel The power supply blank panel is removed to install a redundant power supply. To remove the power supply blank panel: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the two T-15 screws securing the power supply cover plate to the chassis. 3. Pull the power supply cover plate away from the chassis. Figure 2-35. Removing the power supply cover plate Reverse steps 1 through 3 to replace a power supply cover plate. CAUTION: The power supply cover plate or the optional hot-plug redundant power supply must be present in bay 2 to maintain proper cooling of drive bays. Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide