HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 72
Check that the Array Accelerator, Run the System Configuration
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
3-15 POST Error Messages Continued Error Code Audible Beeps L=Long S=Short 1793-Drive Array - None Array Accelerator Battery Depleted - Data Lost (Error message 1794 also displays.) Probable Source of Problem This indicates that while the system was in use, power was interrupted while data was in the Array Accelerator memory. Array Accelerator batteries failed. Data in Array Accelerator has been lost. Recommended Action Power was not restored within eight to ten days. Perform orderly system shutdowns to avoid data remaining in the Array Accelerator. 1794-Drive Array Array Accelerator Battery Charge Low. Array Accelerator is temporarily disabled. Array Accelerator will be re-enabled when battery reaches full charge. None This is a warning that the Replace the Array Accelerator board if battery charge is below 75%. batteries do not recharge within 36 Posted-writes are disabled. power-on hours. 1795-Drive Array Array Accelerator Configuration Error. Data does not correspond to this drive array. Array Accelerator is temporarily disabled. None This indicates that while the Match the Array Accelerator to the system was in use, power was correct drive array, or run the System interrupted while data was in Configuration Utility to clear the data in the Array Accelerator memory. the Array Accelerator. The data stored in the Array Accelerator does not correspond to this drive array. 1796-Drive Array Array Accelerator Not Responding. Array Accelerator is temporarily disabled. None Array Accelerator is defective 1. Check that the Array Accelerator or has been removed. is properly seated. 2. Run the System Configuration Utility to reconfigure the Compaq IDA-2 without the Array Accelerator. 1797-Drive Array - None Hard parity error while reading Enable Array Accelerator. Array Accelerator data from posted-writes Read Error Occurred. memory. Data in Array Accelerator has been lost. Array Accelerator is disabled. Continued Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide