HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 61
Power-On Self-Test POST, POST Error Messages
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
3-4 Diagnostic Tools Power-On Self-Test (POST) POST is a series of diagnostic tests that run automatically on Compaq computers when the system is turned on. POST checks the following assemblies to ensure that the computer system is functioning properly: s Processors s Keyboard s Power supply s System board s Memory s Memory expansion boards s Controllers s Diskette drives s Hard drives POST Error Messages If POST finds an error in the system, an error condition is indicated by an audible and/or visual message. If an error code displays on the screen during POST or after resetting the system, follow the instructions in Table 3-1. The error messages and codes listed in Table 3-1 include all codes generated by Compaq products. Your system generates only those codes that are applicable to your configuration and options. In each case, the Recommended Action column lists the steps necessary to correct the problem. After completing each step, run the Diagnostics program to verify whether the error condition has been corrected. If the error code reappears, perform the next step, then run the Diagnostics program again. Follow this procedure until Diagnostics no longer detects an error condition. Error Code A Critical Error occurred prior to this power-up 101-ROM Error 101-I/O ROM Error 102-System Board Failure 104-ASR-2 Timer Failure Table 3-1 POST Error Messages Audible Beeps L=Long S=Short Probable Source of Problem None A catastrophic system error, which caused the server to crash, has been logged. 1L,1S System ROM checksum. None Options ROM checksum. None DMA, timers, and so on. None System board failure. Recommended Action Run Diagnostics. Replace failed assembly as indicated. Run Diagnostics. Replace failed assembly as indicated. Run Diagnostics. Replace failed assembly as indicated. Replace the system board. Run the Compaq System Configuration Utility. Run Diagnostics. Replace failed assembly as indicated. Continued