HP ProLiant 3000 ProLiant 3000 Servers Maintenance and Service Guide - Page 18
Locking Casters, Remove the three T-25 screws securing each caster to the caster mounting support.
View all HP ProLiant 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
2-5 Locking Casters To remove the locking casters: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Place the server on its side. 3. Remove the three T-25 screws securing each caster to the caster mounting support. 4. Pull the locking casters away from the server. Figure 2-1. Removing the locking casters Reverse steps 1 through 4 to replace the casters. Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
2-5
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
Locking Casters
To remove the locking casters:
1.
Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2.
Place the server on its side.
3.
Remove the three T-25 screws securing each caster to the caster mounting support.
4.
Pull the locking casters away from the server.
Figure 2-1. Removing the locking casters
Reverse steps 1 through 4 to replace the casters.