HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 Service Manual (A5 - Page 139
Step 3: Install Mounting Rails, Step 4: Install the Controller Enclosure
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Installation Step 3: Install Mounting Rails Select the rail kit for the appropriate rack and follow the instructions included with the rail kit to install the rails in the rack. The following rail kits are available for use with the controller enclosure: • HP A5250A for legacy HP Racks ((C2785A, C2786A, C2787A A1896A, or A1897A) • HP A5251A for HP Rack System/E • HP 5656A for Rittal 9000 racks Step 4: Install the Controller Enclosure Note Prior to installing the controller enclosure, it may be easier to preform some of the installation steps described later in this chapter. For example, you may want to connect the MIA's, perform the Fibre Channel Host ID switch settings, and connect the SCSI terminators. 1. Remove the front cover by pulling out on the bottom and sliding it downward, slightly, then pulling it away from the enclosure. WARNING Do not attempt to lift the controller enclosure without the help of another person or a lift device. It weighs 75 pounds. 2. With another person or using a lift, lift the enclosure and slide it, back-end first, into the rack, onto the previously installed rails (Figure 54). Push the enclosure as far into the rack as it will go. 3. Verify that two holes in each mounting ear (B in Figure 54) align with the sheet metal nuts previously installed on the rack front columns. 4. Insert two screws (A in Figure 54) through the holes in the controller mounting bracket that align with the nuts in rack column, on each side of the enclosure. Tighten the screws. Installing the Controller 139