HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 Service Manual (A5 - Page 308
Front Cover Door Removal/Replacement, Disk Enclosure SC10
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
Front Cover Door Removal/Replacement The front door is required for regulatory compliance. Replace the door immediately if it is damaged. The door must be replaced by a trained service representative. The disk enclosure will need to be powered down to complete this procedure. Turning the power off and disconnecting power and SCSI cables eliminates the possibility of inadvertently pulling out live cables and causing an unplanned shutdown when you move the disk enclosure forward in the rack. To replace the front door, complete the following steps: 1. Loosen the enclosure from the rack and slide it forward 2 to 3 inches in the rack. See "Disk Enclosure SC10" on page 304. 1. With the door closed, remove two screws from each hinge block (C in Figure 99). 2. Pull the hinge blocks straight out from the sides of the enclosure, letting the latch hold the door in place. 3. Supporting the door with one hand, unlock (see Figure 97) and remove the door. 308 Internal Disk Enclosure Assemblies