HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 Service Manual (A5 - Page 333
Removing a Controller Module, Front Cover Removal/Replacement
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 333 highlights
Removal and Replacement Removing a Controller Module CAUTION Electrostatic charges can damage sensitive components. Use a grounding wrist strap before removing or handling the controller modules and place the controller module on an antistatic mat when working on it. Removing a controller module that is operating normally (not failed) could result in data loss. Only remove a controller module if its Fault LED is on. Note If you are upgrading a single controller disk array FC60 to a dual controller array, you may need to add a Fibre Channel I/O adaptor to the host system. This will require shutting the host system down to install the adaptor card. If you are replacing a functioning controller because you suspect it may be causing problems, the state of the controller should be set to Failed before removing it. When the new controller is installed, its status should be set to Unfailed. 1. Remove the front cover. See "Front Cover Removal/Replacement" on page 322. 2. Squeeze the two center tabs inward and, at the same time, swing out the two latch handles to release the controller module (see Figure 112). 3. Pull out on the controller latch handles to remove the controller from the enclosure. Controller Enclosure Modules 333