HP Surestore Disk Array FC60 HP SureStore E Disk Array FC60 Service Manual (A5 - Page 307
Installing the Disk Enclosure SC10, Installation,
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 307 highlights
Removal and Replacement Installing the Disk Enclosure SC10 This procedure provides installation steps to reinstall a disk enclosure into a rack. This procedure is a shortened version of the installation procedure provided in Chapter 3, Installation. To replace the disk enclosure into the rack, complete the steps below. 1. Using two people, lift the enclosure into the rack. Slide the enclosure as far forward as it will go. 2. Unlock and open the front cover door. 3. Insert and tighten the front mounting screws (A in Figure 99) to secure the front of the enclosure to the rack columns. 4. Reinstall the rail clamps. Install two screws into each of the two rail clamps (D in Figure 98) at the rear of the disk enclosure 5. Reconnect the SCSI cable(s), terminators, and power cords. 6. Verify that the configuration switches are set to the correct setting for the new installation. If a new enclosure is being installed, ensure that the DIP switch is set for either full-bus or split-bus mode and that the Enclosure (Tray) ID is unique for the installation. See "Configuration Switches" on page 142 for more information. 7. Power on all disk enclosures. Note It can take several minutes for all the disk modules to spin up and the enclosure to become completely functional. Use the Array Manager 60 commands to check the status of the disks. Some disks may remain unavailable for several minutes. 8. Power on the controller enclosure. Set both power switches at the back of the enclosure to on (|). 9. Check that the LEDs are green. 10. Close and lock the door 11. Perform necessary system administration to return file systems to service. Internal Disk Enclosure Assemblies 307