Sony PMWF3K Operating Instructions - Page 29

PLAY/PAUSE F FWD L UP PLAY/PAUSE F FWD L UP Preparations R R Attaching the Microphone Two channels (CH-1/CH-2) of audio can be recorded (Linear PCM recording) in synchronization with video recording. Using the Supplied Microphone Attach the microphone as follows: 1 Loosen the screw of the microphone holder and open the cover. 2 1 2 Set the microphone on the holder with the UP indication facing up. UP 3 Close the microphone holder cover for the original condition to secure, then connect the microphone cable to the AUDIO IN connectors (CH-1 and CH2) and secure the cable at the cable clamp under the holder. Cable clamp 1 2 3 Connect the white plug of the supplied microphone to the CH-1 connector of the camcorder and the red plug to the CH-2 connector. 4 Set the LINE/MIC/MIC+48V switches (CH-1 and CH-2) to MIC+48V. CH-1AUDIO IN LINE CH-2 MIC MIC+48V LINE MIC MIC+48V CH LINE/MIC/MIC+48V switch 5 Set "EXT CH Select" of "Audio Input" (page 106) of the AUDIO SET menu to "CH-1/CH-2." Note Even when recording CH-1 for 2-channel monaural by setting "EXT CH Select" of "Audio Input" (page 106) of the AUDIO SET menu to "CH-1," set the LINE/MIC/MIC+48V switch for CH-2 to the same position as that for CH-1. However, if a microphone which supports both stereo and monaural modes is connected and power of +48 V is supplied to CH-2, the microphone is not switched to monaural mode, but the directivity goes the left channel side. For such a microphone, set the LINE/MIC/MIC+48V Attaching the Microphone 29