Sony PMWF3K Operating Instructions - Page 31
Replacing the battery in the IR Remote, Commander, WARNING, CAUTION
View all Sony PMWF3K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Preparations Note To avoid malfunctions, the remote control function is automatically deactivated when the camcorder is turned off. Activate the function each time when required after you turn the camcorder on. Battery lifetime When the lithium battery's power falls, the IR Remote Commander may not work even if you press the buttons. The average lithium battery's service life is about one year, but this depends on the pattern of use. If pressing the remote control buttons produces absolutely no effect on the camcorder, replace the battery then check the operation again. Replacing the battery in the IR Remote Commander Use a commercially available CR2025 lithium battery. Do not use any battery other than a CR2025. 1 Hold down the lock lever 1, pull out the battery holder 2, and remove the battery. WARNING • Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire. • Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. 2 1 2 Place a new battery in the battery holder with the + symbol facing upward 1, then push the battery holder into the IR Remote Commander until it clicks 2. With the + symbol upward 1 2 Using the IR Remote Commander 31