Yamaha MD4S Owner's Manual - Page 15
Stereo Inputs, Monitor/Master Level 5/6, 7/8 controls, CUE MIX TO STEREO switch
View all Yamaha MD4S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Front and rear panel 15 Stereo Inputs H Level (5/6), (7/8) controls These controls adjust the level of the signals input from STEREO INPUT jacks 5/6 or 7/8. These input signals are always sent to the ST bus, and are mixed with the signals from input channels 1-4 8 and the playback signals of the tracks. 5/6 7/8 0 10 0 10 Monitor/Master section I CUE MIX TO STEREO switch This switch turns the cue mix function on/off. When the switch is pressed in ( ), the CUE MIX indicator in the display will light, and the signal from the CUE bus will be mixed into the ST bus. The cue mix function can be used only during playback, and is 9 normally used when adding sounds during mixdown (page 42). J MONITOR SELECT switches These switches select the signal that will be monitored from the MONITOR OUT jacks (rear panel 4) and the PHONES jack (front panel 1). When the switch is pressed in, the J corresponding source is selected (on). When the switch is up, the signal will not be selected (off). The three switches can be turned on/off independently. 2TR IN Monitor the signal that is input from the 2TR IN jacks (rear panel 6). STEREO Monitor the ST bus signal that is output from K the STEREO OUT jacks (rear panel 5). CUE Monitor the CUE bus signal. K MONITOR LEVEL control L This control adjusts the output level of the monitor signal that is sent to the MONITOR OUT jacks (rear panel 4) and the PHONES jack (front panel 1). L STEREO fader This adjusts the output level of the ST bus that is output from the STEREO OUT jacks (rear panel 5). The fader will be at unity gain when located between 7 and 8. Unity gain: Refer to the explanation of 7 Fader. CUE MIX TO STEREO MONITOR SELECT 2TR IN STEREO CUE MONITOR LEVEL MIN 10 9 8 7 6 5 4 3 2 1 0 MAX 10 9 8 7 6 5 4 3 2 1 0 STEREO -Owner's Manual