Yamaha MD4S Owner's Manual - Page 63

Quick search functions 63 2. Press the TOC WRITE button to update the TOC. Note: If you turn off the power of the MD4S without updating the TOC, the marker settings will be lost. Locating to a marker 3. Use the MARK SEARCH[ ]/[ ] buttons to locate to a marker you inserted. The MARK SEARCH [ ] button will locate to a marker earlier than the current location, and the MARK SEARCH [ ] button will locate to a marker after the current location. The MD4S will then enter playback-pause mode. If no marker has been inserted, the MARK SEARCH [ ] button will locate to the start marker (the beginning of the song), and the MARK SEARCH [ ] button will locate to the end marker (the end of the song). Start marker Marker 1 Current location Marker 2 Marker 3 End marker Tip: The marker indicator in the display shows the marker that corresponds to the current location. When an indicator for a marker you inserted is blinking, the current location is between that marker and the next marker. Start marker Marker 1 Current location Marker 2 Marker 3 End marker Marker indicator S 1 2 3 E Adjusting the location of a marker or auto punch-in/out point Here's how you can make fine adjustments in steps of a single frame to the location of a marker or an auto punch-in/out point. This procedure can be performed when the MD4S is stopped or when it is in playback-pause mode. 1. Press a MARK SEARCH button or a LAST REC SEARCH button to locate to the marker or auto punch-in/out point whose location you wish to adjust. 2. Press the ADJUST button. If you pressed a MARK SEARCH button in step 1, the display will indicate "MARK X:ADJST" (X will be the number of the marker that you selected), and "MARK X" will be blinking. If you pressed a LAST REC SEARCH button, the display will indicate "IN:ADJST" (auto punch-in point) or "OUT:ADJST" (auto punch-out point). At this time you can rotate the DATA dial to select another marker or auto punch-in/out point. -Owner's Manual