Yamaha RS7000 Owner's Manual - Page 137

14. Pattern & Phrase Editing - The Pattern Jobs 4 Rate [Settings] 000% ~ 200%, *** Specifies the percentage by which the target notes will be shifted from their original velocities. Settings below 100% reduce the velocities, and settings above 100% increase the velocities proportionately. When the Set All parameter is not "OFF" this parameter appears as "***" and cannot be changed. 1 Phrase [Settings] 001 ~ 256 2 Range [Settings] Measure:Beat:Clock 001:1:000 ~ 257:1:000 Sets the range of measures/beats/clocks over which the job is applied. 3 Set All The Pattern Mode Original velocity (Vel) 96 Rate = 50% (Vel) 48 Rate = 150% (Vel) 127 64 48 32 32 24 16 96 72 48 [Settings] Off (0), 0001 ~ 9999 2 Sets the gate times of all target notes to the same fixed value. When set to "OFF" the Set All parameter has no effect. When set to a value other than "OFF" the Rate and Offset parameters are unavailable and appear as "***" on the dis- play. 4 Rate 5 Offset [Settings] 000% ~ 200%, *** [Settings] -127 ~ +127, *** Adds a fixed value to the Rate-adjusted velocity values. A setting of 0 produces no change. Settings below 0 reduce the velocities, and settings above 0 increase the velocities. When the Set All parameter is not "OFF" this parameter appears as "***" and cannot be changed. Specifies the percentage by which the gate time of the target notes will be changed. Settings below 100% shorten the notes, and settings above 100% lengthen the notes proportionately. When the Set All parameter is not "OFF" this parameter appears as "***" and cannot be changed. Original velocity (Vel) 96 Rate = -20 (Vel) 76 Rate = +20 (Vel) 116 64 48 32 44 28 12 84 68 52 03 Modify Gate Time This job alters the gate times of the specified range of notes. Gate time changes are calculated as follows: Adjusted gate time = (original gate time × Rate) + Offset If the result is 0 or less, the value is set to 1. 1 2 Original gate time (Gate) 32 32 32 48 Gate time rate = 50% (Gate) 16 16 16 24 Gate time rate = 150% (Gate) 48 48 48 72 5 Offset [Settings] -9999 ~ +9999, **** Adds a fixed value to the Rate-adjusted gate time values. A setting of 0 produces no change. Settings below 0 shorten the gate time, and settings above 0 lengthen the gate time. When the Set All parameter is not "OFF" this parameter appears as "****" and cannot be changed. Original gate time (Gate) 32 32 32 48 Offset = -20 (Gate) 12 12 12 28 5 [Knob 2] 4 3 [Knob 3] [F4] Offset = +20 (Gate) 52 52 52 68 RS7000 137