Yamaha RS7000 Owner's Manual - Page 20
Rear Panel with Optional AIEB2 I/O, Expansion Board Installed, Options, RS7000, OPTICAL - samples
View all Yamaha RS7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
The Controls & Connectors Rear Panel with Optional AIEB2 I/O Expansion Board Installed MUSICAL INSTRUMENT 379U US LISTED MIDI POWER CAUTION ON/ OFF RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR. WARNING TO REDUCETHE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. AC INLET MODEL SER. NO. MADE IN JAPAN THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLWWING TWO CONDITIONS: (1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,AND (2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIVED,INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. IN INPUT OUTPUT SCSI FOOT SW CONTRAST R L R L/MONO PHONES OUT A OUT B OPTICAL IN OUT DIGITAL IN OUT ASSIGNABLE OUT AS6 AS5 AS4 AS3 AS2 AS1 1 2 3 1 OPTICAL IN, OUT Connectors Digital input and output for connection via optical cable. Digital signals to be recorded (48 kHz, 44.1 kHz, or 32 kHz fs) can be connected to OPTICAL IN. OPTICAL OUT delivers the same signal as the OUTPUT L/MONO and R jacks in digital form (fs = 44.1 kHz). 2 DIGITAL IN, OUT Connectors Digital input and output in S/P DIF format (the format normally used by home-use CD or DAT equipment) for connection via coaxial (RCA-pin) cable. Digital signals to be recorded (48 kHz, 44.1 kHz, or 32 kHz fs) can be connected to DIGITAL IN. DIGITAL OUT delivers the same signal as the OUTPUT L/MONO and R jacks in digital form (fs = 44.1 kHz). 3 ASSIGNABLE OUT 1 ~ 6 Jacks Unlike the STEREO OUT outputs, the output from individual tracks can be assigned to these outputs. (Page 21) The ASSIGNABLE OUT jacks can be used as mono outputs or as stereo pairs (1&2, 3&4, 5&6). Options A range of options are available to give the RS7000 even greater music production capabilities. Expansion Memory (SIMM) Recorded samples and samples loaded from memory card must be stored in the internal memory in order to be played. The RS7000 comes equipped with 4 MB of memory which allows up to 46 seconds of monaural sample recording or playback at the maximum 44.1 kHz sampling frequency. Additional memory (SIMM) can be installed to allow much longer sample recording and playback. If you need longer sample recording and playback time, or want to keep a large number of samples in memory at the same time, you may need to add extra memory. See page 274 of the Appendix for details on installing extra memory. 20 RS7000