Yamaha RS7000 Owner's Manual - Page 242

3. Sample Editing 1 ZOOM IN/OUT Knob 1] [Settings] IN, OUT Rotate counter-clockwise to zoom in. Rotate clockwise to zoom out. Above a certain zoom-in level, the waveforms near the start and end points will be shown on the left and right halves of the display. 2 ZOOM F1] When the ZOOM IN/OUT parameters is set to IN or OUT, each press on this button zooms the waveform display either in or out, respectively. 3 START Point, START (ATCK) Point, START (LOOP) point Knob 2] [Settings] 0 ~ END Point Sets the sample start and/or loop start points. When PLAY MODE = FORWARD, REVERSE, or LOOP Sets the START point. When PLAY MODE = ATK+LOOP [F2] switches between START(ATCK) and START(LOOP). Sets the initial sample start point when START(ATCK) selected. Sets the loop START point when START(LOOP) selected. NOTE The PLAY MODE parameter is set in the Sample Parameter page (Page 242). 4 END Point Knob 3] [Settings] START Point ~ End of sample Specifies end point of the sample. 5 STEP Knob 4] [Settings] ×1, ×10, ×100, ×1000, ×10000, ×100000 Sets the "magnification factor" to be used when [Knob 2] and [Knob 3] are used to specify the START and END points. Higher settings allow higher value changes. 6 START ATCK / LOOP F2] [Settings] START(ATCK), START(LOOP) START(ATCK)...... Sets the sample start point. START(LOOP)...... Sets the loop start point. When the PLAY MODE is set to ATK+LOOP this button switches the parameter to be adjusted by [Knob 2]. The button alternately selects the START(ATCK) and START (LOOP) parameters. START(ATCK) .......Sets the initial playback start point for the sample. START(LOOP) ........Sets the point at which the sample loop begins. 7 AUDITION F4] The sample will loop between the specified START and END points while this button is held. This lets you hear precisely how the settings are affecting the sample. 8 VOICE (Sample Voice Number) [Settings] Sample Voice Number 001 ~ 128 are local sample voices; C001 ~ C128 are common sample voices. Sample Name ...... Display only. Key Number (when a Sample Kit Voice is selected) C-2 ~ G8 Displays the number and name of the sample voice assigned to the currently selected track. When a Sample Kit Voice is assigned to the current track, the key number can be changed to change the sample to be edited. Refer to "Sample Edit Procedure", step 3, on page 241 for information on changing the track and key number. 9 Sample Information [Settings] All are display only. Sampling Frequency .... kHz Mono/Stereo MONO, STEREO Sample Type KIT (Sample Kit Voice), PITCHED (Pitched Voice) Shows the sampling frequency, mono/stereo status, and sample type (KIT, PITCHED) of the selected sample. [2] Sample Parameters [SAMPLE EDIT] × 2 Sample Voice = PITCHED VOICE 6 7 242 RS7000 1 [Knob 1] [SHIFT]+[F1] 4 5 [Knob 4] [F4]