Yamaha RS7000 Owner's Manual - Page 233
RS7000, TRIGGER LEVEL, PUNCH-IN/OUT, ASSIGN KEY, ORIGINAL KEY, Track Number, Sample Voice Number
View all Yamaha RS7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
1. Recording Samples (Sampling) 2 TRIGGER LEVEL, PUNCH-IN/OUT ..........[Knob 4] 7 Sampling Time [Settings] TRIGGER LEVEL 0 ~ 127 PUNCH-IN/OUT PATTERN MODE ..... PUNCH-IN 001 ~ 255, PUNCH-OUT 002 ~ 256, END SONG MODE PUNCH-IN 001 ~ 998, PUNCH-OUT 002 ~ 999 Sets the trigger level when the LEVEL trigger mode is selected, or the punch-in and punch-out measures when the MEASURE trigger mode is selected. The trigger level is the signal level at which sampling will begin. The punch-in/out measures are the measure numbers at which sampling will begin and end. Press [F4] to move the cursor to move the cursor to the PUNCH-OUT parameter. 3 ASSIGN KEY Knob 1] Displays the available sampling time. NOTE • The total amount of available sampling time depends on the amount of memory installed. • Sampling time can sometimes be increased by executing the OPTIMIZE function. • The sampling time will not be displayed when the SLICE + SEQ sampling type is selected. 8 Sampling Frequency, Mono/Poly Displays the sampling frequency and mono/stereo settings made in the Sampling Setup page (Page 231). [Settings] C-2 ~ G8 9 Level Meter This parameter is available when the KIT or KIT+NOTE sample type is selected. Specifies the Sample Kit Voice note to which the recorded sample will be assigned. If a sample is already assigned to the specified note "USED" will appear, and "EMPTY" will appear if the specified note is unassigned. A sample previously assigned to the specified note will be erased and replaced by the newly assigned sample. 4 ORIGINAL KEY Knob 1] [Settings] C-2 ~ G8 This parameter is available when the PITCH sample type is selected. Specifies the key (note) that will play the sample at the pitch at which it was originally recorded. 5 Track Number [Settings] 01 ~ 16 The number of the selected track 6 Sample Voice Number The currently selected sample voice number (the number of the next empty sample voice if a sample voice is not currently selected). The displayed sample voice will be overwritten when sampling is executed. 001 ~ 128 are local sample voices, and C001 ~ C128 are common sample voices. Displays the level of the input signal. A clipping indicator will appear to the right of the level meter if the input signal is too large. NOTE • The input signal level can be adjusted by using the [REC VOLUME] control when the A/ 5 D INPUT source is selected. • When the STEREO OUT source is selected The Sampling Mode use the PATTERN or SONG mode MIXER sub mode settings (Page 93, 194) to set the levels of each track. • If the input signal is too large when the A/D INPUT source is selected and the [REC VOL- UME] control cannot provide enough adjust- ment, or if the input level is too small, try changing the input gain setting. Press [SETUP] twice from the SONG or PATTERN mode to go to the A/D Setup page, then use [Knob 1] to select MIC or LINE, as required. • Try to get the input level as high as possible without clipping for the best sound quality. • The input level cannot be adjusted when the DIGITAL or OPTICAL source is selected. Trigger Conditions Page NOTE Select a sample voice via the PATTERN or SONG mode MIXER Voice Select page (Page 93, 194) before press the [STANDBY/START/ STOP] button to go to the sampling mode. This display appears while waiting for the sampling trigger. This page is selected by pressing the [STANDBY/START/STOP] button when the TRIGGER MODE is set to LEVEL or MEASURE. Sequencer playback will begin automatically if the sample type is set to KIT+NOTE. RS7000 233