Yamaha RS7000 Owner's Manual - Page 235

1. Recording Samples (Sampling) 2 START Point Knob 2] [Settings] 0 ~ End Point Specifies the point in the sample that is to be the beginning of the measure. When the Trim function is executed only the portion of the sample between the START and END points will remain. All other data will be deleted. Slice Page The recorded sample is divided in to a number of "slices", the size of which is determined by the specified note length. When the SLICE+SEQ sample type is selected, this page can be selected from the Trim page by pressing [F4] (OK). NOTE The sample is played back from the START point when the [AUDITION] button is pressed, so use this capability to precisely locate the desired start point. If the timing of the first desired beat or sound is cut off or delayed when the [AUDITION] button is pressed, adjust the START point so that it is heard exactly on the beat. NOTE It is necessary to accurately adjust the length of the sample before executing the slice operation. Use the [F2] (AUDITION) button in the Trim page to loop the sample and precisely set the trim START and END points as required. • The Initial Slice Display 6 3 END Point Knob 3] [Settings] START Point ~ End of sample Specifies the point in the sample that is to be the end of the measure. When the Trim function is executed only the por- tion of the sample between the START and END points will remain. All other data will be deleted. 12 3 74 95 [F2] [Knob 1] [F1] [Knob 2] [Knob 3] [F4] [Knob 4] 5 NOTE Set the END point after setting then START point. The sample will loop while the [AUDITION] button is held, so you can hear precisely if the END point is set at the appropriate location. • The Display After Slice Has Been Executed 6 The Sampling Mode 4 STEP Knob 4] [Settings] ×1, ×10, ×100, ×1000, ×10000, ×100000 Sets the "magnification factor" to be used when [Knob 2] and [Knob 3] are used to specify the START and END points. Higher settings allow higher value changes. 5 AUDITION F2] The sample will loop between the specified START and END points while this button is held. This lets you hear precisely how the settings are affecting the sample. 6 OK F4] Executes the normalize and trim operations. The Slice page will appear automatically after execution. 7 VOICE (Sample Voice Number) The sample voice number to which the sample will be saved. 001 ~ 128 are local sample voices; C001 ~ C128 are common sample voices. 1 [Knob 1] 2 7 8 [F1] 3 [F2] 4 [F3] [Knob 2] [Knob 3] 5 9 [F4] [Knob 4] 1 MEAS (Measure Knob 1] [Settings] 1 ~ 8 Specifies the number of measures in the sample to be sliced. When the slice operation is executed, sequence data corresponding to the specified number of measures is created. The sequence data is created from the beginning of the nearest measure at the point at which sampling is started. RS7000 235