Yamaha RS7000 Owner's Manual - Page 287
When the [PLAY] Button Is, Change When Playback Is
View all Yamaha RS7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
3. Troubleshooting Sound Is Cut Off Playback Does Not Begin When the [PLAY] Button Is Pressed Rhythm and Note Timing Is Different From When Recorded Voice & Effect Settings Change When Playback Is Started Can't Record a Phrase or Song Can't Record Samples Memory is Full Even Though There Are Available Patterns or Songs MIDI Bulk Data Transmission/Reception Won't Work Properly Can't Save Data • Are you exceeding the maximum polyphony of the instrument? • Does the selected pattern, phrase, pattern chain, or song contain data? • Is the MIDI SYNC parameter set to INTERNAL? (Page 62) (Page 77, 161, 184) (Page 260) • Are the groove or play effect parameters set to change the timing? (Page 85, 87, 191, 192) • Is data which resets the tone generator recorded at the beginning of the sequence? (Page 154, 225) • Is a preset phrase selected? (Page 75) • Is memory protection turned on? (Page 257) • Have you exceeded the maximum allowable number of sample voices? (Page 61, 229) • Is there enough free sample memory? (Page 68) • Is the source input set properly? (Page 231) • Is the A/D level set properly? (Page 108, 200) • The total RS7000 memory capacity determines the number of patterns, (Page 68) phrases, and songs that can be recorded. For example, if the memory con- tains phrases or songs that use up a large amount of memory, the memory may become full even though the available pattern or song numbers are not all used. • Was the dump interval time set to too short a value when the data was saved? (Page 258) • Is the memory card or disk being used write protected? • Is the memory card or disk being used properly formatted? (Page 115) (Page 116) Appendix RS7000 287