Yamaha RS7000 Owner's Manual - Page 143

14. Pattern & Phrase Editing - The Pattern Jobs 5 Data 1 Phrase [Settings] 000 ~ 127 (-8192 ~ +8191 for pitch bend data) Specifies the lower and upper limits for the data range to be created. The left value is the lower limit, and the right value is the upper limit. [Settings] 001 ~ 256 2 Range [Settings] Measure:Beat:Clock 001:1:000 ~ 257:1:000 6 Clock Sets the range of measures/beats/clocks over which the job will be applied. [Settings] 001 ~ 999 Specifies the number of clocks to be inserted between each 3 Event Type created event. [Settings] PB (Pitch bend) CC (Control change):000 ~ 127, ALL 2 7 Curve [Settings] -16 ~ +16 CAT (Channel aftertouch) PAT (Polyphonic aftertouch) Specifies the "curve" of the continuous data. Selects the event type to be thinned. Refer to the graph below for approximate curve shapes. The Pattern Mode Curve = +16 Curve = 0 (linear) Curve = -16 16 Modify Control Data Start point End point This distance specified by Clock Changes the values of a specified type of control change data - pitch bend, control change, aftertouch, etc. - in the specified range. The data value is calculated as follows. Value = original data × Rate + Offset. If the resultant value exceeds the allowable range it will be set to the maximum or minimum value. 15 Thin Out 1 2 Thins out the specified type of continuous data in the specified range to save memory space. NOTE The Thin Out job will not work on continuous data that has a clock interval of greater than 60 clocks per event. 1 2 3 [Knob 2] [Knob 3] [F4] 3 6 4 [Knob 2] 5 [Knob 3] [F4] 1 Phrase [Settings] 001 ~ 256 2 Range [Settings] Measure:Beat:Clock 001:1:000 ~ 257:1:000 Sets the range of measures/beats/clocks over which the job will be applied. 3 Event Type [Settings] PB (Pitch bend) CC (Control change):000 ~ 127, ALL CAT (Channel aftertouch) PAT (Polyphonic aftertouch) Selects the event type to be modified. RS7000 143