Yamaha RS7000 Owner's Manual - Page 288

4. Error Message List 4. Error Message List G Operational Errors No Data Illegal Input Illegal Track Number Illegal Phrase Number Illegal Measure Illegal Check Box Meter Mismatch No F7 (End Of Exc.) Preset Phrase Pattern Length Mismatch Phrase Length Mismatch Phrase Number Overflow Too Long Sample Too Short Sample Too Low Freq Digital In Unlocked G System Errors Backup Battery Low Sequence Memory Full Sample Number Overflow Too Many Local Voices Too Many Common Voices Too Many Sample Voices Wave Memory Full Factory Set When a job is executed, the selected track or range contains no data. Select an appropriate track or range. An unacceptable input or value has been specified. Check the input method or value. An unacceptable track number has been specified. Select the track again. An unacceptable phrase number has been specified. Select the phrase again. An unacceptable measure number has been specified. Select the measure again. No check boxes have been checked in a track job which requires a check box selection. Check the appropriate check box. The meter values of the original and edited data are different. Exclusive data has been entered or changed without the necessary "End Of Exclusive" byte (F7). Make sure F7 is included. You have attempted to edit or record a preset phrase. Preset phrases must be copied to a user phrase before they can be edited. A job will result in the length of a phrase being greater than 256 measures. An edit operation will result in a phrase which is longer than 256 measures. The maximum number of phrases (256) has been exceeded when recording, executing a job, or editing. A sample time stretch or other job has resulted in a sample being too long. The sample length is too short and the Frequency Convert job cannot be executed. The sampling frequency is too low and the Frequency Convert job cannot be executed. The DIGITAL/OPTICAL input is unlocked. Check the connections and the output from the source device. The internal backup battery is running low. Have the battery replaced by your YAMAHA dealer or an authorized YAMAHA service center. The internal memory is full and recording, editing, job execution, MIDI reception/transmission, or loading from card or disk cannot continue. Try again after erasing unwanted song, pattern, or user phrase data. A sampling operation, job, or load operation has exceeded the maximum allowable number of samples. Try again after erasing unnecessary samples. The maximum number of samples allowable for a pattern or song (128) has been exceeded. The maximum allowable number of common sample voices (128) has been exceeded. The maximum overall number of sample voices (256) has been exceeded. The wave memory is full and further sampling operations, jobs, or load operations cannot be executed. In some cases, the amount of remaining memory will be increased when you execute the Wave Memory Optimize operation. This message appears when the RS7000 is restored to the initial factory settings (Page 25). The data in internal memory can be corrupted when the backup battery voltage runs too low, for example, and all data will automatically be restored to the factory settings, causing this message to appear. 288 RS7000